Note: This product will eventually be replaced with the new PC/II+dxe.
The PC/II+i is a high-integration 4x4Family embedded
single-board microcomputer. This board contains a complete IBM® PC compatible
CPU with on-board video and disk controllers, peripheral controllers, networking
capability, low power consumption and a small rugged design for embedded control.
The PC/II+i incorporates the Intel 486 SL Chip Set with full
32-bit DRAM Data Bus. This high performance CPU executes the 486 instruction
set with floating point and all operating systems designed for this set. The
PC/II+i Ethernet interface utilizes the Intel 82595 single-chip Ethernet controller
and its buffered slave architecture.
PC/104 connectivity is also available for this board with
the addition of the QTB/104 break-out board, enabling design engineers to
"stack" other PC/104 cards onto their system.
PC/II+i Photographic
Image (JPG,63k)
Selection Guides
CPU
& MEMORY
- Intel 486 SL
CPU, at 25MHz or 33MHz
- Full 32-bit
DRAM Data Bus
- Built-in 8K
Cache; Floating Point unit
- 486DX compatibility
and performance
- AT compatible
BIOS and architecture
- Up to 256 KB
BIOS in Flash EPROM
- 4 or 16 MB User
DRAM options
- DOS® in ROM
- Up to 2 MB Programmable
Flash configured as a hard disk
- PC/104 or ISA
Bus Compatible (with adapter)
|
INPUT
/ OUTPUT
- On-board 16-bit
PC Bus expansion
- Standard IBM
PC Keyboard Port
- 8-bit general
purpose Parallel I/O port, IEEE 1284 Compatible
- 2 IBM compatible
RS-232C Serial Ports
- 1 additional
PC compatible BIOS, RS-232C serial port
- Voltage converter
for Serial +/- voltage
- Independent
s/w select baud rates
- AT Real-time
clock with battery backup
- M-Systems Flash
File System
- AT Keyboard
Port
|
VIDEO
CONTROLLER
- Super VGA/LCD
controller
- Supports color
LCD panels
- Supports Analog
VGA monitors
|
SCSI
CONTROLLER
- 53C80 SCSI interface
- Standard IBM
PC AT Hard Disk BIOS via SCSI port (INT 13)
- Complete interface
for SCSI hard drives
- Supports CD
ROM's, audio devices and optical storage for multimedia
- ASPI compatible
software drivers
|
ETHERNET
CONTROLLER
- On-board Ethernet
LAN Controller (Local Area Network)
- Automatic or
manual switching between TPE and AUI ports
- 16-bit I/O accesses
local DRAM with zero added wait-states
|
MISCELLANEOUS
- Only 100 x 100
mm (4" x 4")
- Requires only
+5v operation
- Power consumption
of 6 watts
- (typical for
33MHz board with
- 4 MB DRAM installed)
- Operating temperature
range 0C - +70C
- MTBF: Not less
than 200,000 hours
|
FLOPPY
- CMOS Floppy
Disk Controller
- Will support
up to two drives
- 360 KB, 720
KB, 1.2 MB, 1.44 MB
- Will boot standard
versions of PC, MS or DR DOS®
|
